Method Statement · Sign Fitters
Method Statement for Sign Fitters
A safe system of work: the numbered, step-by-step sequence for carrying out the task safely, that an operative can actually follow. Below: what a sign fitter's Method Statement must contain, why they get rejected, and the hazards it has to cover, or generate one for your exact job in a couple of minutes.
What a compliant Method Statement must contain
- A numbered sequence from set-up to clean-down
- The specific plant, equipment and isolation points named at each step
- Measurable checks where a step proves safety (e.g. prove dead, hold zero-pressure 30s)
- Competence requirements and PPE
Why a sign fitter's Method Statement gets rejected
- Abstract steps ('isolate and verify') with nothing measurable
- A likelihood × severity scoring table bolted on (that belongs in the risk assessment)
- Steps that skip the actual sequence a job really follows
- No named competent person where the law requires one
Already have one? Check it against the standard, free.
Paste your RAMS into the free checker and it scores it the way an inspector would, and flags exactly what would get it rejected. No sign-up.
Check yours freeSign Fitters hazards it must cover
Typical sign fitter work, meaning Supply and fix internal and external signage including fascia boards, projecting signs, built-up letters, illuminated units and wayfinding systems to commercial and public premises, brings hazards a Method Statement has to address:
- Working at height on ladders, MEWP or scaffold to fix signage to elevations
- Electrical connection of illuminated signs requiring isolation and safe working on live systems
- Manual handling of large, heavy or awkward sign panels and frames
- Drilling and cutting into masonry or structural substrates releasing respirable crystalline silica (RCS)
- Contact with adhesives, solvents and vinyl laminates requiring COSHH assessment
- Asbestos in pre-2000 building fabric disturbed when drilling fixings
Generate your Method Statement in minutes
Built to the correct published standard for a sign fitter: specific controls, the right legal basis, a review date and a sign-off section you can operate.
Start your Method StatementFAQ
Do sign fitters legally need a Method Statement?
A safe system of work: the numbered, step-by-step sequence for carrying out the task safely, that an operative can actually follow. For sign fitter work, meaning Supply and fix internal and external signage including fascia boards, projecting signs, built-up letters, illuminated units and wayfinding systems to commercial and public premises, it is the document a client, principal contractor or inspector expects to see, grounded in the recognised safe-system-of-work format (HSE guidance).
What makes a sign fitter's Method Statement fail?
The usual reasons: Abstract steps ('isolate and verify') with nothing measurable; A likelihood × severity scoring table bolted on (that belongs in the risk assessment); Steps that skip the actual sequence a job really follows. RAMSReady generates one to the correct published form and avoids these.
How fast can I get a Method Statement?
A couple of minutes. Describe the job, and RAMSReady writes a Method Statement for your exact sign fitter job live against the correct standard, with a review date and a sign-off/records section.