Method Statement · Welders & Fabricators
Method Statement for Welders & Fabricators
A safe system of work: the numbered, step-by-step sequence for carrying out the task safely, that an operative can actually follow. Below: what a welder & fabricator's Method Statement must contain, why they get rejected, and the hazards it has to cover, or generate one for your exact job in a couple of minutes.
What a compliant Method Statement must contain
- A numbered sequence from set-up to clean-down
- The specific plant, equipment and isolation points named at each step
- Measurable checks where a step proves safety (e.g. prove dead, hold zero-pressure 30s)
- Competence requirements and PPE
Why a welder & fabricator's Method Statement gets rejected
- Abstract steps ('isolate and verify') with nothing measurable
- A likelihood × severity scoring table bolted on (that belongs in the risk assessment)
- Steps that skip the actual sequence a job really follows
- No named competent person where the law requires one
Already have one? Check it against the standard, free.
Paste your RAMS into the free checker and it scores it the way an inspector would, and flags exactly what would get it rejected. No sign-up.
Check yours freeWelders & Fabricators hazards it must cover
Typical welder & fabricator work, meaning welding, cutting and metal fabrication on site and in the shop, brings hazards a Method Statement has to address:
- welding fume, now a Group 1 carcinogen (COSHH/LEV)
- hot works, fire and burns
- UV arc-eye and manual handling
- compressed gas cylinders
Generate your Method Statement in minutes
Built to the correct published standard for a welder & fabricator: specific controls, the right legal basis, a review date and a sign-off section you can operate.
Start your Method StatementFAQ
Do welders & fabricators legally need a Method Statement?
A safe system of work: the numbered, step-by-step sequence for carrying out the task safely, that an operative can actually follow. For welder & fabricator work, meaning welding, cutting and metal fabrication on site and in the shop, it is the document a client, principal contractor or inspector expects to see, grounded in the recognised safe-system-of-work format (HSE guidance).
What makes a welder & fabricator's Method Statement fail?
The usual reasons: Abstract steps ('isolate and verify') with nothing measurable; A likelihood × severity scoring table bolted on (that belongs in the risk assessment); Steps that skip the actual sequence a job really follows. RAMSReady generates one to the correct published form and avoids these.
How fast can I get a Method Statement?
A couple of minutes. Describe the job, and RAMSReady writes a Method Statement for your exact welder & fabricator job live against the correct standard, with a review date and a sign-off/records section.