RAMS · Electricians
RAMS for Electricians
A combined Risk Assessment & Method Statement — the site-ready document a principal contractor or client asks for before you start. Below: what a electrician’s RAMS must contain, why they get rejected, and the hazards it has to cover — or generate one for your exact job in a couple of minutes.
What a compliant RAMS must contain
- A hazard table with a likelihood × severity score before and after controls
- Controls in the correct hierarchy (eliminate → substitute → engineering → admin → PPE last)
- A numbered, step-by-step method statement for the actual task
- PPE to BS EN standards, emergency arrangements, and an operative sign-off
Why a electrician’s RAMS gets rejected
- Residual risk dropped from high to low on PPE or 'competent operatives' alone
- Generic hazards that could apply to any job
- No method statement, or one too vague to follow on site
- The wrong legal basis cited (e.g. 'CDM 2015 requires a RAMS')
Already have one? Check it against the standard — free.
Paste your RAMS into the free checker and it scores it the way an inspector would, and flags exactly what would get it rejected. No sign-up.
Check yours freeElectricians hazards it must cover
Typical electrician work — installations, rewires, consumer-unit changes, testing and fault-finding — brings hazards a RAMS has to address:
- electric shock (dead working the default under EAWR 1989)
- working at height on steps and towers
- asbestos in pre-2000 fabric
- manual handling of cable drums and boards
Generate your RAMS in minutes
Built to the correct published standard for a electrician — specific controls, the right legal basis, a review date and a sign-off section you can operate.
Start your RAMSFAQ
Do electricians legally need a RAMS?
A combined Risk Assessment & Method Statement — the site-ready document a principal contractor or client asks for before you start. For electrician work — installations, rewires, consumer-unit changes, testing and fault-finding — it is the document a client, principal contractor or inspector expects to see, grounded in MHSWR 1999 reg 3 (HSE) — the combined risk assessment + method statement contractors submit.
What makes a electrician's RAMS fail?
The usual reasons: Residual risk dropped from high to low on PPE or 'competent operatives' alone; Generic hazards that could apply to any job; No method statement, or one too vague to follow on site. RAMSReady generates one to the correct published form and avoids these.
How fast can I get a RAMS?
A couple of minutes. Describe the job, and RAMSReady writes a electrician-specific RAMS live against the correct standard — with a review date and a sign-off/records section.